Torsion springs are installed to lift most of the weight of a garage door so the door is able to be opened manually or with a remote opener. The springs wear out over time, and if you are handy with tools and repairs this could be a DIY project for you to have a ball with over a weekend. For others who are not so handy; there are repairmen who can replace the garage door torsion spring.
When attempting to replace the torsion spring, be sure to have a partner that can stand by for an extra set of hands or if anything should go wrong. If you decide to repair the garage door yourself, this article might provide some tips that can help you with the job.
Springs come in all different sizes. When you purchase your springs, be sure to get the ones that are the correct springs for the job. Consider the wire size, winding diameter, and length so it will provide the correct amount of torque. For safety reasons, be sure the spring is able to handle the weight it will bear. A spring popping off and hitting someone in the head is not a good scenario, so do this job right. It is a good idea to replace both springs at the same time so they will get equal wear and tear.
Compare prices at different shops and be sure that the shops carry the spring you need. If you can not find a spring for your Installation For Garage Door needs, shop on line and find a provider on the internet. Have the measurements ready to help get the right size and length.
As you replace the springs it is a good time to check the ropes and pulleys or cables that are used to raise and lower the door. Swing Up Garage Door Hardware They get wear and tear as well. Removing the problems before they start will make the whole system work for many more years.
Check the door itself for stress problems and level hanging. Check the door for proper insulation and tighten all screws down. The rails need to be firmly affixed so that the pulleys do not have to struggle to do their job. The smooth raising and lowering of the door is made possible by the springs being able to pull and lower the weight of the garage door.
As you replace the garage door torsion spring be sure to have the equipment and tools on hand that you will need and place them in an area that is easily accessible to you. Once the job is complete, be sure to check your work. The door should run the rails smoothly and the spring should be strong enough and provide enough torque to easily lift and lower the door.
With attention to safety and purchasing the correct materials, you can replace your own garage door torsion spring. The spring and the rails of the pulley system are important to smooth operation. The rope or cable used needs to be in good, strong condition. Be careful and save yourself some money and replace your own garage door torsion spring.
