Garage Door Troubleshooting Tips

The garage door is a complex mechanical system with many moving parts that can break; springs, pulleys, cables, brackets. While many doors are built and installed to last for a long time without maintenance, eventually something is going to happen. So if you are having garage door problems do not fret, there are a number of reasons it may be acting up and some of them can be taken care of by you at no or low cost. Read on to learn a few troubleshooting tips for your garage door.

The first thing you should do if you are having trouble with your garage door is to check the power on your opener. While “Is it plugged in?” may sound silly, Garage Doors Parts Suppliers it would be sillier to spend time troubleshooting mechanical parts only to find out the electric cord was accidental unplugged or a fuse had blown.

Next check the batteries in your door opener remote is not dead. Again, another quick and simple check can save you headache and frustration.

If the power cord is plugged in and your batteries are good but your door still wont open the next thing you should do is look at the track that the door runs along. This will be on either side of the door and has ball bearings allowing the door to easily roll up and down inside of it. Do a visual inspection to see if there has been any damage; bending, warping, or something wedged inside. If there is something stuck inside, remove it with a screw driver. Never put your fingers inside the track. If it is dented, use a hammer and try to lightly tap it back into shape. If the track is too severely damaged you will need to call a company to replace it. Many companies, from garage door repair in Las Vegas to a service company in Maine will often give you a quote right over the phone.

READ  4 Garage Door Openers And How To Program Them

Check the sensors are aligned properly and are plugged in. These are located at the base of the door and look like tiny cameras. They shoot an infrared beam that tells the system their is nothing obstructing the path of the door. If this beam is broken or not turned on the garage door will not operate.

If after having gone through these steps you are still having trouble it is best to call a professional. Everything up to this point is fairly safe and low risk to you. However Local Garage Door Installers as this is a system that is under tension it is possible to make a mistake that could loosen something, causing a part to go flying and seriously injure you or damage property.